New Old Stock Tennessee Bow Stops for Boat Trailer Winch Stands @ $19.99 each
Short Version is 6.5 inches from mounting point to 55 degree V (10.25 inches overall)
Long Version is 11.25 inches from mounting point to 100 degree V (14.125 inches overall)
V angles can be modified though
Constructed of (2) pieces of .1875 inch by 1.25 inch Painted Steel Bar Stock with Black Vinyl Sleeves
Mounting Flange is drilled with (2) .375 holes and is designed for a 2.25 inch wide Winch Post with mounting by a U bolt.
New SeaFare Trailer Coupler Safety Locking Pin
New SeaFare Trailer Coupler Safety Locking Pin @ $5.49
Prevents Unwanted Unlatching of Coupler Mechanism
New Old Stock Tennessee Trailers Bolt-On Frame Crossmember
New Old Stock TENNESSEE TRAILERS Bolt-On Frame Crossmember @ $49.99
1960s-70's Style, Designed to bolt between frame rails
Drilled and tabbed for roller or bunk brackets in six locations.
47 & 1/8 Overall 2 & 1/2" Wide by 2" High U Tubing 5" by 3" End Plates Approximately 3" Drop
New Old Stock Tennessee Trailers "Drive-On" Style Fender
New Old Stock TENNESSEE TRAILERS Drive-On Style Boat Trailer Fender @ $39.99
Off-White with Black Racing Tape Stripes and Tennessee Decals
Early 1970s Style, Designed to bolt-on, Fits Left or Right, Drilled for Marker Lights
Carpeted Pad can be Installed to Inside Vertical Face to Guide/Protect Hull
Usually Used with 13 & 14 Tires
34 Maximum Length (at bottom) 10 1/8 Width 12 1/8 Height 25 1/4 Length (boat side) by 10 1/8 Width by 18 5/8 Length (outside) Flat Fender Top
Mallory 10 ounce Tube of Marine Bearing Grease
Mallory 10 ounce Tube of Marine Bearing Grease @ $6.99
"Premium quality multi-purpose lubricant engineered t withstand the most extreme marine environments" "Low bleed formulation maintains lubricant where it's needed most, on the bearing surface" "Outstanding rust and corrosion protection even at elevated temperature" "Ideal for u-joint, gimbal bearing, wheel bearings, cable slides, and anywhere else a premium quality multi-purpose lubricant is to be used"
Used Vintage Life-Line Bow Tie Down Strap
Used Vintage Life-Line Bow Tie Down Strap @ $4.99
Very good condition, but the white straps are somewhat soiled.
Intended for up to 21" distance from boat's bow eye to trailer attachment point, but a length of small chain can be added at the spring end for greater spans.
Used "The Hugger" Gunnel Tie Down
The Hugger - Gunnel Tie Down - Used @ $19.99
This product is based on the design of a flat-bed (tractor) trailer tie-down, except made for marine use.
It conveniently rolls-up the strap when it is not in use.
Plugs into existing factory connectors, no wire splicing.
Connector dust boot and tube of terminal grease included.
New Dico 13" by 5.5" 5-Lug Chrome Spoke Trailer Wheels
New Dico 13" by 5.5" 5-Lug Chrome Spoke Trailer Wheel @ $49.99 each
New Springfield "Over The Roller" Transom Saver
New SPRINGFIELD Adjustable Length "Over The Roller" Style Transom Saver @ $24.99
This quality transom saver has plastic motor and trailer ends with (2) anodized aluminum square tubing sections for adjustable length and corrosion prevention (no steel to rust), and includes a rubber strap to secure to the outboard or outdrive.
The trailer end is designed to encircle the rear trailer roller with a notch and slot retaining style. The motor end can then be rotated into position more positively.
New BoatBuckle Transom Tie Downs
New BoatBuckle Transom Tie Downs @ $17.99 (bagged as a pair)
Webbing for Buckle and Dipped "S" Hook help to protect boat finish from marring.
We tried quite a few brands of transom tie downs, and we strongly feel that these are the best.
New Roadrunner Trailers Winch Mount
New Roadrunner Trailer Avocado Green 7 & 5/8" high Winch Mount @ $39.99
Winch Plate is 6" long by 4" wide channel iron
Post is 3" by 3" tubing
Base Plate is 6" long by 3" wide bar stock
Attachment to trailer tongue by U-bolts with plates (not included)
New Trailers, Inc. Winch Post & Stand Assemblies
Heavy Gauge Steel Construction In (3) Styles @ $79.99 each
Drilled: To Accept A Winch On Top, For Attachment To A 3" Wide Trailer Tongue (normally using U-Bolts), and Bow Stop Arms For Attachment Of A Roller
Gray Fixed Height (two sections of welded channel iron form center section)
Gray or Tan Adjustable Height (overlapping tubing center )
Gray or Tan Adjustable Height (overlapping tubing center) with Extra Long Arms
New 1/2" By 20' Black Twisted Polypropylene Winch Rope
New 1/2" By 20' Black Twisted Polypropylene Winch Rope @ $8.99
New L S Brown Square U-Bolt
New L S Brown .375" diameter, 2" inside width, 5.75" inside length Zinc Plated Square U-Bolt with Lock Washers & Nuts @ $3.49